This is a listing for Custom Maker's Mark leather/pottery stamps laser cut into the face of a 3" tall Delrin stamp block.
It is a custom "build to order" purchase.
When
I receive the order I will make the laser format artwork and send you
an image for your approval. So, watch for messages.
Once the artwork is approved by you I will cut and ship the stamp.
If
I don't receive your approval within 5 days I will cut the stamp as
ordered and ship it. In other words, I will not sit on your purchase.
There are no custom order charges when ordering from this listing.
Most of the design work is already done. All that is left is adding your text. That only takes a few minutes.
***Please fill in the text you want with the lines separated by a comma.***
3 lines maximum, 11 characters/line maximum.
Please enter any special instructions.
If a graphic is requested please attach your artwork.
The stamp block face size is 1" x 3/4" and is 3" tall.
The mark will be 0.08" smaller than the face of the block.
--------
These stamps are cut with an industrial laser with a resolution of 0.1mm (0.004"). Not a "made in china" system.
The stamp depth of cut is 0.120" deep so that the stamp block does not leave a mark on thick leather.
The stamp walls use a swept fillet to reinforce the walls. Take a close look at the stamp face walls in the photo.
Every stamp is tested in a 1-ton arbor press. I have yet to break one, and I 'lean' on it.
Before I started using a press I would test the stamp in cased
leather placed on concrete and wack it with a 1 lb ball-peen hammer
without leaving a dent or breaking any part of the stamp. A press gives
me more control than a hammer.
Each stamp is 3" tall so that it can be used with a dead-blow hammer, a mallet, or an arbor press. - See press image -
Each stamp blank is faced on both ends with a CNC mill before it
goes in the laser so that the band saw tracks are removed from the ends
and to make it square.
The stamps are made from Delrin, a very strong acetyl homo-polymer commonly used in making gears.
For more information check out my web site for a paper I wrote on using
Delrin for leather stamps.
All stamps carry the Made in Montana USA logo laser etched into the side of the block.
How to order. Select the border you want and add text or artwork, preferably as high a resolution as possible.
If you are in a rush, please let me know.
*With Maker's Mark/Custom stamps, I will send you proof artwork for approval.
If i don't hear from you in 5 days, I will cut the stamp as-is. So watch your email.
I will contact you from there
Who is Vollkommen Enterprises LLC?
A Montana registered LLC
and a
Registered Member in the "The Made in Montana USA" Program which is
part of Office of Trade & International Relations in the Business
Resources Division the of the Montana Department of Commerce.
Surf my web site to get a better impression of me.
http://www.vollkommen.com
Questions?
To ask a private question, click the "CONTACT US" link at the top and email me. Otherwise use the "questions about this item" form.
If you wish to send me your artwork to see if it will work before ordering, attach it to an email using the contact us page.
What can I make for you?
